• Welcome to Jetboaters.net!

    We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

    Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

    free hit counter
  • Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

    Click Here for more information>Ride Steady group buy for JetBoaters.net members only

    You can dismiss this Notice by clicking the "X" in the upper right>>>>>

Diagnostic Tool

PatrickKolby

Jet Boat Addict
Messages
107
Reaction score
71
Points
97
Boat Make
Yamaha
Year
2021
Boat Model
212S
Boat Length
21
Hi Everyone,

Had a slight overheat from sucked up seaweed today (port engine). Overheat light came on along with the CEL and limp mode activated. Once the weeds were cleared out of the clean out ports the boat ran fine and the overheat light went off.

The CEL is still on and from what I’ve read in other forums it may go off after 3-4 clean starts.

Question. Who makes a diagnostic tool for consumers on these boats?I’ve tried searching but can’t find what people are using for 2021 OBDII w/ Connext Screens.
 
I am not sure what the interface is on a 2020/2021
But this is what I have
Yds pro2
 
Thanks. I emailed that company for more info. I’ll report back.
 
They replied back and have the YDS Pro2 works for our boats. It’s $399

The good news is that after 5 starts the CEL went away.
 
I just had this same problem, but from running on a hose, with a kink in the port side hose that I didn't see. Temp alarm went off and I shut down in the correct order (water first). The engine cooled down and the temp alarm went off, but still getting the CEL on the port side 2 weeks later. Boat has .6 hrs and never been in the water (don't ask why I was running on the hose, just was - maybe too anxious to hear it run). I am 3 hrs from the dealer/mechanic, so would really like to reset it myself. What is the restart procedure. Is it a full start and stop of the engines and turning the key all the way off each time, etc... I have turned the key off and on over 5 times, and the battery disconnect switches the same number. Any advice to not have to take it in would be very appreciated! Thanks! Also trying to decide if I should get the YDS Pro2 being this far from the mechanic in case something like this happens again.
 
My CEL went off after I did 5 full engine starts. Do not turn off your battery switches. Leave them on during this whole process.
 
They replied back and have the YDS Pro2 works for our boats. It’s $399

The good news is that after 5 starts the CEL went away.
Can you tell me what company you emailed. I talked to a Yamaha dealer, and they are not available to the public. Curious what you were told. Thanks
 
Back
Top