Brad Dunn
Jet Boat Addict
- Messages
- 157
- Reaction score
- 39
- Points
- 117
- Location
- British Columbia
- Boat Make
- Yamaha
- Year
- 2016
- Boat Model
- Other
- Boat Length
- 24
Anyone done one? Tips or directions
Thanks
Thanks
-
Welcome to Jetboaters.net!
We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!
Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
16 242 x reverse cable replacement help
- Thread starter Brad Dunn
- Start date
- Tagged users None
Cambo
Jetboaters Captain
- Messages
- 1,278
- Reaction score
- 899
- Points
- 227
- Location
- Long Island
- Boat Make
- Yamaha
- Year
- 2017
- Boat Model
- 242X E-Series
- Boat Length
- 24
what happened to the cable ? did you try to lube it up before replacement ? I had success on an older model forcing light weight oil with PB blaster using a hose clamped on by the jet nozzle. Then disconnected the cable at the throttle attached to a drill and spun it slowly while pulling it in and out
Brad Dunn
Jet Boat Addict
- Messages
- 157
- Reaction score
- 39
- Points
- 117
- Location
- British Columbia
- Boat Make
- Yamaha
- Year
- 2016
- Boat Model
- Other
- Boat Length
- 24
The end broke right off. So no saving it.
Cambo
Jetboaters Captain
- Messages
- 1,278
- Reaction score
- 899
- Points
- 227
- Location
- Long Island
- Boat Make
- Yamaha
- Year
- 2017
- Boat Model
- 242X E-Series
- Boat Length
- 24
What made the end brake off did the servo controller have enough power to snap it? It should be fairly simple to remove but keep us posted on what the complete process is . You should need some type of special tool to remove the nut on the thru hull connection . The floor / gas tank cover will need to be removed . Apply a heat gun to the Allen key bolts that hold the floor down to help break the loc title if they get tight while loosening turn them back in and then out they can snap.