2016 Scarab Impulse 255 HO Wake have problem with eReverse U0410(EREV)

[Kartoshka_Mitya]

Hello guys, I have 2016 Scarab Impulse 255 HO Wake, and also I have problem with my eReverse Module, error code: U0410(EREV). I have stored it in a hangar for the winter in +17 celsius, but three weeks ago I have low battery, I charged it and then check the boat, it still have this error. I have already checked all fuses, they are all OK.
My questions are:
1. How can I fix eReverse module error?
2. What is the name of eReverse Fuse and Relay?
3. Where stayed eReverse Relay?
4. Someone says that, when I was taking off my battaries the reverse module switches to "Safe Mode", can it be true?



P.S. do not watch to P1130
p

 

[GrabACabCC]

I just got the U0410 ereverse error after two months of no use. I read the forums and checked all the fuses. Came down to the tether line for the automatic cut off switch. I don't know if this clip that goes on the cut-off switch gets worn over time and allows the switch to engage and cut off the engine but from now on, I will be storing the boat with the clip off. To fix the error I pulled off the tethering clip and pushed in on the switch (button) with my finger and held it there while I turned the key off and on again. The error didn't come up and the throttle position on the display showed 'N' instead of 'F'. I tried the engine start buttons and both engines fired up. I replaced the clip and started engines again, everything is fine. I also charged my battery. Not sure how much that had to do with the issue. It was at 13v and now at 14.4v. Hope this helps someone else. Have fun guys!

 

[GrabACabCC]

Update to this report. It was a low battery. Battery has to be fully charged or you will get that code. Also after charging, seems like it needs a minute to reset when boat is turned on.