sbeassie
Well-Known Member
- Messages
- 26
- Reaction score
- 39
- Points
- 52
- Location
- Baton Rouge
- Boat Make
- Yamaha
- Year
- 2024
- Boat Model
- 222SD
- Boat Length
- 22
I'm planning to replace the OEM locked down Wet Sounds amp with two new amps. I plan to run 1/0awg cable for power and ground and use distribution blocks to reduce to 4awg for each amp. Where is the best place to connect power and ground? I've done amp installation many times in vehicles but not a boat. Should I connect directly to the posts of the house battery? I also found house and ground bus bars in the engine compartment but I'm not sure if these can supply a load up to 200A. I haven't looked but I'm thinking there may be a ground bus under the helm but once again is this sufficient for this application?



