Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

General Discussion

AT309 install

Thread starter Fordjet
Start date May 9, 2021

Fordjet

Member

May 9, 2021

I have a new river boat I have purchased, I pulled it out of the water for the first time and was looking at the AT 309 installation. The tiller or steering arm has been cut and the tip ground off and new mounting hole drilled, just wondering if anyone has done this or seen this done, it’s a little disappointing as it is a new boat, also wondering if this install would affect the overall steering as it seems like it has. Attached pictures