• Welcome to Jetboaters.net!

    We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

    Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

    free hit counter
  • JetBoaters.Net 2nd Annual SeaDoo Switch Group Buy Sponsored By JetBoatPilot Is Live Now. Save 25% Off Select SeaDoo Switch Gear through October 31st.

    Click Here to go to the Jetboatpilot Seadoo Group buy

    You can delete this notice with the "X" in the upper right>>>

BOW TABLE MOUNT YAMAHA 252 series

Vinny Dip

Active Member
Messages
3
Reaction score
4
Points
42
Boat Make
Yamaha
Year
2019
Boat Model
242 Limited S E-Series
Boat Length
Other
has anyone tried installing a table mount on the bow of the 252 series?
 
I have not done it but I've seen it done. It's the same set up as the one on the stern. I installed one where the battery switches are.
 
I would be very interested to see pictures of this. Also where did you get the hardware.
 
If you wanted to use the leg provided with the table, you could just use the bracket in the parts fiche. Otherwise, a floor mount could be used with a new table leg.
 
@HailMary makes table legs and sells the table base attachments as well. Just eye it up and order a new table when you attache the mounts you will have a lot of flexibility in the position

I used this table

 
Anyone done this? I have a 23’ 252SD and want to add a mount at bow to put the table. Be nice if someone has a how to or some pics of the process. I always get nervous drilling holes in this boat without knowing exactly what I’m doing.
 
Didn't mount one in the bow but did relocate the swim platform remote and ordered a new bracket. The factory yamha has a back plate so that when the table leg is inserted the table is level but a few plastic washers inserted on the lower bolt through areas positioned the plate to the correct alignment.
 
Anyone done this? I have a 23’ 252SD and want to add a mount at bow to put the table. Be nice if someone has a how to or some pics of the process. I always get nervous drilling holes in this boat without knowing exactly what I’m doing.

I'd be interested in this as well. I have a grill mount that I use in the existing bracket so no place to set up the table while cooking. Would be great so the kids have a surface other than my clean seats to spill their food on!
 
Back
Top