Scooter442
Active Member
- Messages
- 13
- Reaction score
- 0
- Points
- 40
- Boat Make
- Yamaha
- Year
- 2020
- Boat Model
- 242 Limited S E-Series
- Boat Length
- 24
Looking to extend the SeaDek for the rear swim platform on our 2020 242SE. There is about a 1.5" area from where the SeaDek ends to the chrome middle piece that gets scratched very easily on both sides and I would like to add a piece on each side.
Do they make a piece for this or can I buy a sheet long enough and cut it out myself, hoping it will hold since it is on a beveled area or I will just do 2 separate pieces on each side.
Thanks in advance.
Do they make a piece for this or can I buy a sheet long enough and cut it out myself, hoping it will hold since it is on a beveled area or I will just do 2 separate pieces on each side.
Thanks in advance.