Wake Wedge - Install Question

[OnTheWater]

Hey All,

Need a little help - I'm attaching a few pics. When I used the template it didn't cover the entire ladder bracket, so I did it according to the 1st picture(aligned to right). That led to an issue where I can't get the washer on because of the indent on the inside of the ladder bracket(pic 2). Should I have done something similar to pic 3(aligned to left) or is there another recommendation?

Ran out of time yesterday, so didn't mess around with it.

Thanks!

 

[mattschepker]

@jcyamaharider

 

[jcyamaharider]

The bracket is on backwards, and the button head part should be on the inside of the ladder and the washer and nut on the outside of the ladder. The recess should be touching the factory bracket and position the bracket parallel. Give me a call if you have more questions.

 

[OnTheWater]

Thanks much - I'll take a look later and will call if I have any questions.

 

[OnTheWater]

@jcyamaharider That worked - always easier when you're not bumping up against the clock. Thanks for the support. Here's a couple of pics...

 

[jcyamaharider]

Looks great!!! Wedge angle looks just about right as well!

 

[jcyamaharider]

@jcyamaharider That worked - always easier when you're not bumping up against the clock. Thanks for the support. Here's a couple of pics...
View attachment 36838 View attachment 36839

One quick note about the last pic with the pin. IF the pin can be pushed in farther it should be because it looks like when the wedge moves up a little bit it could bend the pin, also try putting it in from the back side.