• Welcome to Jetboaters.net!

    We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

    Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

    free hit counter

Yamaha FX won’t start: battery good.

jlcj7

Jetboaters Captain
Messages
729
Reaction score
687
Points
232
Location
Tega Cay, SC
Boat Make
Yamaha
Year
2011
Boat Model
SX
Boat Length
21
Any suggestions: 2019 FX HO Cruiser.

Went to start jet ski and “click” and connect screen goes dark. I assumed battery was dead so took it out to charge. Before charging it read 12.6V. I charged it anyway until fully charged. Put it back in and still nothing. No corrosion on terminals or cables. Weirdly, starting shaking cables (mainly to see if they ran to a relay or solenoid that maybe went bad). Didn’t see anything obvious (in terms of loose connections etc)

Randomly I tried to start again and it fired up. Let sit for a min and started up a second time.

Any ideas of what could cause this? Now I fear I’ll get out somewhere and have an issue. Is there a relay or something that may be going bad potentially? Maybe battery issue even though fully charged?

Appreciate any suggestions.
 
Make sure all cables are clean and tight................I had the battery main switch fail one time ...................turned it on and nothing no power to boat. Cycled it off and back on and everything worked fine.......a little corrosion on the switch possibly........ never had a problem since.

A click usually means the starter solenoid tried to engage but since the connect lost power that usually means the loss of a ground wire/cable. Ground wire is the only cable that will take out both at the same time.
 
Back
Top