2014 212x/212ss Bow roller???.??

[AZMark]

I was trying to research this on here because I just had the same issue with the Stoltz setup that fits these 210/212s.

I somehow got on the trailer about an inch crooked and the stoltz rollers compressed enough to allow the metal to dig into the hull. I think I may try and buy the bigger end bells for a little more protection.

 

[Ratket]

I was trying to research this on here because I just had the same issue with the Stoltz setup that fits these 210/212s.

I somehow got on the trailer about an inch crooked and the stoltz rollers compressed enough to allow the metal to dig into the hull. I think I may try and buy the bigger end bells for a little more protection.

that sucks!. I would try to go 1 size bigger on the mid section and like two sizes bigger on the bell ends. The ramps we frequent are steep as hell, and unless I power load the hell out of it I can never come close to the roller. i know When I change mine out again “ Likely to be a while” that’s what I will do. A little bit bigger on all three pieces I think would give a better contact area and piece of mind that in no way are you getting into the metal.