2016 Ballast Pump Doesnt work

[1BadTundra]

When I flip the switch to either fill or empty, the switch just blinks as I hear a click like a relay back at the controller. But the motor doesnt run... Any ideas?

 

[1BadTundra]

Anyone?

 

[Matt Phillips]

Not sure... Have you tried tried connecting it directly (fused to a battery) to see if it'll run that way? That way you may be able to determine if it's the pump or electronics?

my 2017 has 3 pumps, have you looked to see if you can take out one of the others that's working and put it into the place that's not? That may be a better way to come at it now that I think about it...

 

[1BadTundra]

My 2016 212x only has one pump that splits to two rear saddle mounted OEM bags. I just tried to directly wire to the battery, it works when I hook it up like that. I would like to retain the timer controller. I should add that I do not have the Connectx, just rocker switches and analog gauges.

 

[jcyamaharider]

Maybe a timer failure?

If it did go bad Wakemakers has a jabsco for 150.00 or you could try this one off of Amazon. AITIAO 2Pcs Timer Delay Relay,DC 12V 20A Programmable Digital Cycle Delay Relay Timer Switch Module 1500W ON-Off Control 0ms-999h LED Display: Amazon.com: Tools & Home Improvement

 

[1BadTundra]

Blown fuse was the culprit.The watertight fuse holder was full of water, giving induced voltage readings to my meter. Replaced the 20A fuse, all works now.