Ar240 table leg dimensions

[Fastx021]

Hey everyone, i was wondering if anyone with a table leg could give me the dimensions for it. Specifically the length of the pipe on either side of the bend/weld.

I am not interentsed in paying $200 for a piece of steel when i have access to all the free steel i want and love to fabricate.

I have a 2013 AR240 and using the at the stern on the boat. (Not where the grill mounts on the swim deck). i have a garelick mount

 

[tdonoughue]

Makes sense to me.

Been out of town, but just back now. Boat is 30 min away. Let me see if I can get up there tonight...

 

[tdonoughue]

Ok. I think this is the one you need:


Mid section I measure at 14 1/8 in for the long side; 12 5/8 in for the short side.

Top section I measure at 4 15/16 in for the long side; 4 1/2 in for the short side.

Using an app on the phone, measured the angle of the base to the mid section of 56 degrees (I think it is actually 55). I measured the angle of the bend between mid and top sections at 125 degrees (actually measured 35 degrees, but from the other side...). Anyway, when you add those if you use the 55, you wind up at 170, which means 10 degrees tilt, which is a) likely and b) magically about what I guessed looking at the angle of the whole thing in the first place.

Hope that helps.