Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

Click Here for more information>Ride Steady group buy for JetBoaters.net members only

You can dismiss this Notice by clicking the "X" in the upper right>>>>>

General Discussion

Ar240 table leg dimensions

Thread starter Fastx021
Start date Tuesday at 9:42 PM

Fastx021

Member

Tuesday at 9:42 PM

Hey everyone, i was wondering if anyone with a table leg could give me the dimensions for it. Specifically the length of the pipe on either side of the bend/weld.

I am not interentsed in paying $200 for a piece of steel when i have access to all the free steel i want and love to fabricate.

I have a 2013 AR240 and using the at the stern on the boat. (Not where the grill mounts on the swim deck). i have a garelick mount

You must log in or register to reply here.