Bow roller hardware

[Ballshrinker]

I have 2022 ar195 and purchased stoltz 3.5" center and 434 bell ends. Thinking about switching tomorrow at dock. Do I reuse same hardware or do I need to buy new hardware. I have company with me and don't want a cluster. Any help would be appreciated.

 

[Farny]

I have 2022 ar195 and purchased stoltz 3.5" center and 434 bell ends. Thinking about switching tomorrow at dock. Do I reuse same hardware or do I need to buy new hardware. I have company with me and don't want a cluster. Any help would be appreciated.

Should be easy as pie. I switched mine out in the garage with the boat on the trailer. Pretty sure the old hardware will work. Stoltz didn’t send you a bolt washers and locknut?

 

[Ballshrinker]

I had a hard time figuring out what to get and bought them separately

 

[Farny]

I had a hard time figuring out what to get and bought them separately

I think the existing will work. Good news is even if it doesn’t you’ll only waste about 5 min of your time finding out today. Just bring the correct size wrenches and your good to go.

 

[MrBubbaGump]

Swapped mine out when I parked the trailer at the ramp, just brought a ratchet with the correct socket and a breaker bar with a socket as well... Took about 2 min.

 

[Ballshrinker]

I took it off and tried to put the new ones on but the inside member was too short, like 1/4" gap on both sides. The bolt wasn't long enough but maightve been if the bracket was squeezed together.

Did yall have to squeeze bracket together or did I buy wrong center member?

 

[MrBubbaGump]

I took it off and tried to put the new ones on but the inside member was too short, like 1/4" gap on both sides. The bolt wasn't long enough but maightve been if the bracket was squeezed together.

Did yall have to squeeze bracket together or did I buy wrong center member?

Did not have to squeeze together

 

[Ballshrinker]

I bought stoltz rp335, 3". Was that the right one?

 

[MrBubbaGump]

I have the 210 FSH and i got the Stoltz rp355 3.5 inch Here

 

[Farny]

I bought stoltz rp335, 3". Was that the right one?

I believe I have the 3.5” for my 195. I’ll send a pic in a sec

yep I have the one @MrBubbaGump posted.

 

[Rockit69]

I bought this one and it worked perfect, raised the trailer all the way up and it rolled off the roller about a 1/2" and was able to swap it out at home. I got a new bolt with the set and I think it pinched in a bit, as long as the brackets dont bind against the rollers you should be fine.

3.5" STOLTZ Polyurethane Roller w/ Bells for Shoreland'r Boat Trailers RP-355 | eBay

Find many great new & used options and get the best deals for 3.5" STOLTZ Polyurethane Roller w/ Bells for Shoreland'r Boat Trailers RP-355 at the best online prices at eBay! Free shipping for many products!

www.ebay.com

 

[Cbullard3895]

I have 2022 ar195 and purchased stoltz 3.5" center and 434 bell ends. Thinking about switching tomorrow at dock. Do I reuse same hardware or do I need to buy new hardware. I have company with me and don't want a cluster. Any help would be appreciated.

mine came with new hardware.