Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

Click Here for more information>Ride Steady group buy for JetBoaters.net members only

You can dismiss this Notice by clicking the "X" in the upper right>>>>>

General Discussion

Padding for table stanchion

Thread starter Nakk
Start date Jul 30, 2019

Nakk

Jet Boat Addict

Jul 30, 2019

I got this pipe insulation from Amazon, fits the table leg for my 2017 AR240 perfectly. I cut two pieces, one for the lower section and one for the section above the bend. The lower section needs to be slit--it's partially pre-slit--but the upper section slides right on and doesn't slide off unless you pull it off. It helps prevent damage both to the leg and to other things it might hit if it bounces around while underway. Amazon.com: 2-1/8" x 6 ft. Polyethylene Pipe Insulation, 3/8" Wall: Home Improvement BTW, the picture on Amazon shows the insulation pre-slit with adhesive pre-installed. That is not how mine came. It only is pre-slit about 1/8" through the 3/8" thick wall. No adhesive.

You must log in or register to reply here.