johhnyboat
Jetboaters Lieutenant
- Messages
- 374
- Reaction score
- 258
- Points
- 172
- Location
- Ocean City, MD
- Boat Make
- Yamaha
- Year
- 2016
- Boat Model
- Limited S
- Boat Length
- 24
Can I just replace this part? I just had cable replaced 2 years ago
-
Welcome to Jetboaters.net!
We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!
Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Shifter Cable broke on reverse bucket
- Thread starter johhnyboat
- Start date
Can I just replace this part? I just had cable replaced 2 years ago
ToddW850
Jetboaters Admiral
- Messages
- 1,693
- Reaction score
- 1,548
- Points
- 287
- Location
- Destin, Florida
- Boat Make
- Yamaha
- Year
- 2017
- Boat Model
- 242X E-Series
- Boat Length
- 24
So my boat is a 2017 242X and I have that loaded into Partzilla. If I'm looking at this correctly, looks like you can. Part 26 and/or 27 under "Control Cable" section.
Also looks like you're doing a wear ring replacement? I'm doing the same, but had 2 bolts break off. So turned a quick job into a pain in the neck haha.
Also looks like you're doing a wear ring replacement? I'm doing the same, but had 2 bolts break off. So turned a quick job into a pain in the neck haha.
johhnyboat
Jetboaters Lieutenant
- Messages
- 374
- Reaction score
- 258
- Points
- 172
- Location
- Ocean City, MD
- Boat Make
- Yamaha
- Year
- 2016
- Boat Model
- Limited S
- Boat Length
- 24
Yes, some of the bolts were seized and had to heat them up but the replacement was not too bad. I took the shaft to a local bike shop and they removed the shaft and impellers. Easy to put back on. However, yes I broke the bolt on the reverse bucket cable. I’m thinking I may be able to fix it with just a bolt coupler. If not, I’ll look into that part. Thanks for the reply.
Neutron
Jetboaters Admiral
- Messages
- 4,674
- Reaction score
- 7,330
- Points
- 467
- Location
- New Bern, NC
- Boat Make
- Yamaha
- Year
- Other
- Boat Model
- 252SE
- Boat Length
- 25
Looks like the cable end is bent as well unless its the angle. Something must of been binding up to snap that off
johhnyboat
Jetboaters Lieutenant
- Messages
- 374
- Reaction score
- 258
- Points
- 172
- Location
- Ocean City, MD
- Boat Make
- Yamaha
- Year
- 2016
- Boat Model
- Limited S
- Boat Length
- 24
It’s not. The broken one is on the other side.
Similar threads
