Welcome to Jetboaters.net!

We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)
Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

Click Here for more information>Ride Steady group buy for JetBoaters.net members only

You can dismiss this Notice by clicking the "X" in the upper right>>>>>

General Discussion

A little help. Brother was using my Challenger 180 jet boat and wrapped rope up in the driveshaft

Thread starter bigd59
Start date Aug 22, 2024

bigd59

Member

Aug 22, 2024

My brother was driving while I was trying to get back up on the tube we were pulling. While circling the rope was sucked in so bad it bent the driveshaft. replaced everything. it also burnt the stator up and the stator wires. Also got the ECM. Bought new ECM and had it programmed. Now I have a no spark situation. I have tested CPS and all sensors according to the shop manual and all test good. Two questions, The TOPS sensor has 3 wires, shop manual says I should have 5 volts on pin 2 and 3. I have 5 volts on 1 and 3, none on 2. tested wiring back to the ECM and it's coming out the ECM this way. Second question, I replaced Stator and it all test good but I notice on the Rotor that 75% of it has slight rising where the magnets are and the rest is smoot. Is this normal? I wouldn't think so but that's why I'm asking

You must log in or register to reply here.