• Welcome to Jetboaters.net!

    We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

    Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

    free hit counter
  • JetBoaters.Net 2nd Annual SeaDoo Switch Group Buy Sponsored By JetBoatPilot Is Live Now. Save 25% Off Select SeaDoo Switch Gear through October 31st.

    Click Here to go to the Jetboatpilot Seadoo Group buy

    You can delete this notice with the "X" in the upper right>>>

2019 Yamaha 190 Series updates

Yes same problem, i did splice. In the end, the connext must need a flash as every way I tried it would not recognize the transducer for depth. Ended up putting a Garcin chart plotter for my depth.
 
Ok, thanks for the feedback, very much appreciated. I wondered if that was the case as I noticed all of the wires going into the display were labeled, but I couldn’t find one for depth. Disappointing that Yamaha took this approach and made compatibility so difficult (and didn’t include depth in the first place).
 
Back
Top