• Welcome to Jetboaters.net!

    We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

    Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

    free hit counter

Decals <where to find for 2008 SX230>

danielcasey01

Jet Boat Lover
Messages
86
Reaction score
17
Points
67
Location
Port Republic, NJ
Boat Make
Yamaha
Year
2008
Boat Model
SX
Boat Length
23
My 2008 SX230 has decals which have been worn by the sun. I was hoping to replace and was wondering if anyone knows where I can get them.
Also, how difficult/easy is it to get old decals off?
 

FLBulldogger

Jetboaters Lieutenant
Messages
579
Reaction score
470
Points
152
Boat Make
Boatless
Year
NA
Boat Model
Other
Boat Length
Other
The decals will differ in how difficult or easy they are since you have a 12 yr old boat. I would start with my fingernails and see if you can get one up and going, if you can they should peel off, you can also use Goo gone decal remover, but if they fray or chip when you get it going you may need a heat gun (used sparingly) to get the glue behind the decal to loosing and give as you go. But whatever you do DONT use anything sharp or that has a sharp edge, we've had folks here that did that and gouged the crap out of the gelcoat. Just keep the heat gun on low and keep it moving and at least a foot away. Then once they are off we used you can use the goo gone to get the residual glue off. Here is a link for the DECALS if you choose to reinstall. Once we got out off we liked them gone.. Good luck take some before and after pics.
 

ChrisM

Jetboaters Commander
Messages
400
Reaction score
435
Points
177
Location
Rock HIll, SC 29730
Boat Make
Chaparral
Year
2016
Boat Model
VR
Boat Length
23
I swear by these, but controlled pressure should be used as marring from enough pressure could occur. Controlled heat from a heat gun, and these, have taken many a brittle and cracking decals off for me in the past.

Non-Marring Scraper Set, 4 Pc.
 
Last edited:

zipper

Jetboaters Fleet Admiral 1*
Staff member
Administrator
Messages
7,952
Reaction score
21,592
Points
817
Location
Northern Vermont Lake Champlain
Boat Make
Boston Whaler
Year
1995
Boat Model
Other
Boat Length
18
Heat gun worked well to remove my 07 graphics. I did not reinstall. I wetsanded and polished the hull to remove the oxidized gelcoat. We like it better without graphics.

20170415_141627.jpg

20170430_102323.jpg

20170525_171920.jpg
 

Beachbummer

Jetboaters Admiral
Messages
4,006
Reaction score
2,919
Points
342
Location
Houston TX
Boat Make
Yamaha
Year
2008
Boat Model
SX
Boat Length
23
Top