• Welcome to Jetboaters.net!

    We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

    Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

    free hit counter
  • Guest, we are pleased to announce that Hydrophase Ridesteady is offering an extra $100 off for JETBOATERS.NET members on any Ridesteady for Yamaha Speed Control system purchased through March 7th, 2025. Ridesteady is a speed control system (“cruise control”) that uses GPS satellites or engine RPM to keep your boat at the set speed you choose. On twin engine boats, it will also automatically synchronize your engines.

    Click Here for more information>Ride Steady group buy for JetBoaters.net members only

    You can dismiss this Notice by clicking the "X" in the upper right>>>>>

Mounting a Thru Hull transducer

epoxy the fishfinder transducer to the lowest part of your hull (inside the boat of course lol).
 
Did we ever get to the bottom this depth finder arrow ? Keel or Bow or a mix of both LOL .. where is the arrow suppose to point !?
 
If you are talking about the directional arrrow on the transducer, the arrow points to the forward direction. This is a copy from the RV-200 thru hull installation instructions, we put in the Beneteau.

Screenshot_20210530-082610_Drive.jpg
 
why does arrow say to keel ? its confusing AF ... I removed mine for winter and like a dumb bell forgot to take a picture
 
why does arrow say to keel ? its confusing AF ... I removed mine for winter and like a dumb bell forgot to take a picture

The one I installed was a 0° transducer. The one in the picture above is for a sailboat. They will typically install two, one on either side of the keel. The angles to compensate for the hull on either side of a sailboat keel. Mine is mounted forward of the keel, on a flat section in the hull, just one, and has one arrow on each side embossed in the x-ducer and it points forward to the bow. Picture taken at install.

Screenshot_20210530-092248_Gallery.jpg
 
Last edited:
where would mine have to correct ? its a 20 deg and the arrow is pointing to keel ( in other words ) directly to left of the location hole .. not sure if this is correct though
 
Randomly started checking out some Google search results and stumbled on this, which seemed helpful...


But I would imagine that different transducers may have arrows pointing different ways, no? If it says keel, I would imagine that it should point to the keel (as opposed to the type that points the the bow). I think.
 
where would mine have to correct ? its a 20 deg and the arrow is pointing to keel ( in other words ) directly to left of the location hole .. not sure if this is correct though

If it is similar to this one and has an arrow and keel, then the arrow points to keel.

20210531_122820.jpg
 
Back
Top