Elite 4 HDI Install Advice and Writeup

[Scottintexas]

@Seadeals thanks for the all the details and pictures, added to the FAQ

 

[DBamaC]

I need to start this project soon. Where did you end up getting your power? Have you had any problems with breakers tripping? Thanks!

 

[M@__]

I did this a month or two ago. Since the hole is above the waterline I don't see much to worry about. I added a backup bilge at the same time. The bilge is powered by a mechanical float that is connected to the battery and also a switch that I installed at the helm. So had a new power supply for mine. However, the OEM wires are plenty thick enough to handle the additional current of a fish finder if you don't mind sharing the power switch or leaving it on all the time.

 

[DBamaC]

OK. Thanks.

 

[Noko]

Can you mount this transducer thru the hull? I have an Elite 4 HDI and was wondering I could mount it as a shoot thru the hull.

 

[Seadeals]

Yes, you can mount it from inside the hull in a bed of epoxy.

 

[Noko]

Yes, you can mount it from inside the hull in a bed of epoxy.

Any advantage to mounting externally, better signal? It looks easier to mount it inside.