• Welcome to Jetboaters.net!

    We are delighted you have found your way to the best Jet Boaters Forum on the internet! Please consider Signing Up so that you can enjoy all the features and offers on the forum. We have members with boats from all the major manufacturers including Yamaha, Seadoo, Scarab and Chaparral. We don't email you SPAM, and the site is totally non-commercial. So what's to lose? IT IS FREE!

    Membership allows you to ask questions (no matter how mundane), meet up with other jet boaters, see full images (not just thumbnails), browse the member map and qualifies you for members only discounts offered by vendors who run specials for our members only! (It also gets rid of this banner!)

    free hit counter

Sportster No Start Mystery

Sailorboy58

Member
Messages
2
Reaction score
0
Points
10
Boat Make
SeaDoo
Year
2003
Boat Model
Other
Boat Length
17
This week I bought a 2003 Seadoo Sportster "project" boat. Meaning it had issues with cables. I replaced the throttle and shifter cables after a little bit of searching and some creative fabrication. Cables are good now. However, the boat cranks fine but won't start, or even "pop". I checked for spark. Has spark. New plugs. Fresh gas. Being new to Seadoo Jet boats I'm wondering if I'm missing something in the start-up process perhaps? Are there obvious things I should be checking or looking for? Any suggestions appreciated! Other footnotes. Previous owner installed new short block, new starter and bendex gear.
 

Julian

Jetboaters Fleet Admiral 2*
Staff member
Administrator
Messages
18,358
Reaction score
20,434
Points
1,082
Location
Raleigh, NC 27614
Boat Make
Yamaha
Year
2016
Boat Model
242X E-Series
Boat Length
24

Sailorboy58

Member
Messages
2
Reaction score
0
Points
10
Boat Make
SeaDoo
Year
2003
Boat Model
Other
Boat Length
17
Hi Julian.

Yes lanyard is installed. I have spark. Plugs come out wet and slightly oily after cranking. However, I've discovered that using the deck hose fitting to run cooling water prior to engine start up may cause water to backflow into the manifold and engine. So I've removed plugs, disconnected fuel and oil so I can give it a good cranking to ventilate and hopefully dry it out. We'll see how that goes.
 

Gym

Jetboaters Admiral
Messages
3,258
Reaction score
2,659
Points
337
Location
Falmouth, MA (Cape Cod)
Boat Make
Yamaha
Year
2006
Boat Model
SX
Boat Length
23
You don't need cooling water to start an engine and run it for 15 to 20 seconds. Make sure you have no water in your oil.

With regard to starting...You basically need three things. Fuel. Spark & Air. You mentioned you had spark. You said the plugs were wet. I hope that means wet with fuel and not water. If the plugs are getting fuel make sure you're getting air. Remove the air filter, if equipped, make sure the butterfly is closed during start on a cold engine. If still no start and as much as I hate to use it you may want to squirt a tiny bit of quick start into the air induction system while cranking. If the engine caughs with the quick start it proves you have a functioning engine but something else is at fault.
 
Top